Find HS Code and trade information for 3D PRINTING WIRE

Declaration Breakdown: 3D Printing Wire (HS Code 3916.90.50.00)

Here's a detailed breakdown of the HS code and associated import regulations for your declared item, "3D Printing Wire," originating from China (CN). This analysis aims to provide clarity on classification, tax implications, and essential considerations for customs clearance.

1. HS Code: 3916.90.50.00 – A Deep Dive

The HS code is a globally standardized system used to classify traded products. Let's break down this specific code:

• 39: Plastics and articles thereof. This indicates the primary material of your product is plastic.
• 3916: Monofilament of which any cross-sectional dimension exceeds 1 mm, rods, sticks and profile shapes, whether or not surface-worked but not otherwise worked, of plastics. This narrows down the product to plastic filaments, rods, or sticks. Essentially, it's for plastic forms that aren't complex molded shapes.
• 3916.90: Of other plastics. This specifies that the plastic material isn't one of the specifically listed plastics in earlier categories (like PVC, polyethylene, etc.).
• 3916.90.50: Other. This is a residual subheading, covering plastics not specifically classified elsewhere within 3916.90.
• 3916.90.50.00: Other. This further refines the classification, indicating a general "other" category within the 3916.90.50 subheading. This is often used for a wide variety of plastic filaments, rods, and sticks that don't fit into more specific classifications.

2. Tax Implications

Based on the provided information, the following taxes apply to your import:

• Basic Tariff: 5.8%
• Additional Tariff: 25.0% (Currently)
• Additional Tariff (Post April 2, 2025): 30.0%
• Total Tax: 60.8% (Currently)

Important Note: The additional tariff rate is scheduled to increase to 30.0% after April 2, 2025. This will significantly impact your landed cost.

3. Key Considerations & Recommendations

• Material Verification: Crucially, confirm the exact plastic composition of your 3D printing wire. While classified as "other plastics," specific plastic types could fall under different, potentially more favorable, tariff rates. Provide a detailed Material Safety Data Sheet (MSDS) to customs if requested.
• Single Price Check: The declared value (single price) is a critical factor in customs assessment. Ensure the declared value accurately reflects the transaction value.
• Certification Requirements: Depending on the intended use of the 3D printing wire, you may need to provide specific certifications (e.g., RoHS compliance for restricted substances, REACH compliance for chemical regulations). Check with the importing country's regulations to determine if any certifications are required.
• Country of Origin: Double-check the country of origin documentation. Incorrect origin declarations can lead to penalties.
• Invoice Details: Ensure your invoice includes a detailed description of the goods, HS code, quantity, unit price, total value, and country of origin.
• Post-April 2, 2025 Planning: Factor the increased additional tariff (30%) into your cost calculations for any imports arriving after April 2, 2025. Consider adjusting sourcing or import strategies if the increased cost is prohibitive.

Disclaimer: This information is for general guidance only and does not constitute professional customs advice. Customs regulations are subject to change. It is highly recommended to consult with a licensed customs broker or relevant authorities for accurate and up-to-date information specific to your import situation.