Find HS Code and trade information for GALVANIZED WIRE

Galvanized Wire HS Code Classification

Based on the provided reference data, “GALVANIZED WIRE” can potentially fall into the following HS codes, depending on its specific characteristics:

• 7217.20.15.00: Wire of iron or nonalloy steel; Plated or coated with zinc; Flat wire.

  • 72: Iron and steel. This chapter covers a wide range of iron and steel products.
  • 17: Wire, rods, tubes, plates, electrodes and similar products. This narrows down the category to wire products.
  • 20: Plated or coated with zinc. Specifies that the wire is galvanized (coated with zinc).
  • 15: Flat wire. This further specifies the shape of the wire.
  • Applicable if the wire is flat in shape.

• 7217.20.30.00: Wire of iron or nonalloy steel; Plated or coated with zinc; Round wire; With a diameter of 1.5 mm or more and containing by weight less than 0.25 percent of carbon.

  • 72: Iron and steel.
  • 17: Wire, rods, tubes, plates, electrodes and similar products.
  • 20: Plated or coated with zinc.
  • 30: Round wire with specific diameter and carbon content.
  • Applicable if the wire is round, has a diameter of 1.5mm or more, and contains less than 0.25% carbon by weight.

Important Considerations & Recommendations:

• Shape: Determine whether the wire is flat or round. This is the primary factor in differentiating between 7217.20.15.00 and 7217.20.30.00.
• Diameter & Carbon Content: If the wire is round, measure its diameter. If it's 1.5mm or more, and you have the material composition data, verify the carbon content is less than 0.25%.
• Material Composition: Confirm the wire is made of iron or non-alloy steel. If other alloys are present, a different HS code may be applicable.
• Tax Rate: Both 7217.20.15.00 and 7217.20.30.00 currently have a total tax rate of 30.0% (0% base tariff + 30% additional tariff after April 2, 2025).
• Certification: Depending on the end-use of the galvanized wire, specific certifications (e.g., quality standards, environmental compliance) may be required. Please check the import regulations of the destination country.
• Declaration Accuracy: Ensure the declared HS code accurately reflects the wire's characteristics to avoid potential customs issues and penalties.
• Further Verification: If the wire has a specific application (e.g., welding, brazing), consider 8311.90.00 as a possibility, but requires more information about its use.